Production: 140-160 units / min Fully automatic Area: 3,500 x 2,500 x 2,000 mm. Area 8.25 square meters. - Six step high speed a drag mask machine The rectifying device system refers to the technology adopted by the manufacturer to keep the material side clean and consistent in the process of spraying, rolling, cutting or the other rolling; Rectifier device principle: Rectifier system principle: infrared light / ultrasonic wave / laser / visible light is sent by rectifier sensor B to monitor coil material operation and send signal to controller A. Microcomputer digital controller provides precise control of all system functions. Front details of the high-speed headphones: - Two stepper motors are used for the terminal wire - The scissors are powered by two 400w servo motors; The original pneumatic scissors are abandoned to solve the problem of continuous cutting due to unstable air pressure. - Four 400w servomotors are used to control the clamping of the cable, two on the left and two on the left. - The tie rod is controlled by two 400w servomotors, and the left and right tie rods are controlled by independent servomotors.